git pull default

Patrick Rachford
1 min readDec 8, 2022

One key default I like to use.

Whenever I create a new branch, push it out, then pull to check for updates, I find myself running the following command.

git pull origin branch-name

Then after sometime, I have to run:

    git branch --set-upstream-to=origin/branch-name

What if there was someway to tell Git to pull from the branch name by default?

To configure Git to perform a git pull from the current branch by default, you can use the git config command to set the pull.default option. This option determines the behavior of the git pull command when you don't specify a branch name.

To set the pull.default option to current, you can use the following command:

git config --global pull.default current

This will configure Git to always perform a git pull from the current branch, rather than requiring you to specify the branch name each time you run the command.

Keep in mind that this change will only affect your local Git configuration, and will not affect other users who clone your repository. If you want to share this configuration with others, you will need to communicate the change and ensure that everyone who works on the repository is using the same settings.

--

--

Patrick Rachford

Currently at Temporal, previously at AWS. I enjoy documenting my thoughts and sharing ideas with others.